Author: oskrypuch
Subject: COM2 to speaker
Posted: 07 Jul 2016 at 6:56pm
Edited by oskrypuch - 07 Jul 2016 at 7:10pm
Subject: COM2 to speaker
Posted: 07 Jul 2016 at 6:56pm
 cardinal driver wrote:
... So I could put 121.5 in Standby 1, but then I could no longer make use of the IFD540 FREQ function key functions. Again from the manual: "When a desired frequency has been located in the list, it can be placed into the #1 Standby slot by either double tapping it via touch or pushing the bottom right dual concentric push knob." ... |
Actually, you do not have that quite correctly. There is actually a subtle difference between the references to the first "physical" standby frequency (for the monitor function) always just below the primary frequency, and the "#1 Standby" frequency (for nomination to the primary position, loading freq from the FREQ page, etc.) as set by a screen touch, and as shown by the cyan outline.
You can do exactly as I suggest above, to achieve what you'd like to do. I do this on most every flight.
* Orest
Edited by oskrypuch - 07 Jul 2016 at 7:10pm